Poly Postal Packaging is a leading
UK manufacturer of polythene
and polypropylene packaging.
Choose your colour of Bubble Lined Mailing Bags. Take a note of the comment below the picture which shows the size if required. Then choose the qty of boxes you would like to order. There are 100 per box
These bags have been lined with out clear bubble film which gives them better protection. They are 100% Recyclable and also water resistant. We manufacture the bubble lined postal bags on site here in the UK, as we do all our mailing bags. The bubble lined mailing bags are manufactured from our special 3 layer COEX blended polythene film. The bags are glossy on the outside. We specially treat the film in the manufacturing process so that the glue on the lip sticks permanently as it should and to ensure that the polythene film accepts stamps and your address labels etc.
The bubble lining has been hand inserted and so can be removed if you wish
The outer box measures 500 X 400 X 300mm
A full pallet qty of these bags would be 3000 bags, 30 boxes of 100 per box
Advice & Usage Guide
Use; The bags will arrive laid flat in an outer Carton. Once you unpack the mailing bags, simply slide or drop your product into the mailing bag. An easier method might be to remove the bubble lining, drop your item in that and then push it back inside the outer mailer. The best method for sealing the mailing bag is to then lay it on a flat surface, lip/glue facing up. Peel off the release tape from the lip which covers the glue and then fold the lip over onto the body of the bag. We strongly advise that you only fold the lip over to where it naturally wants to fold to and no further. If you fold the lip right over and seal it, lets say half way down the bag, then there is a chance that the glue will not form a perfect bond and the bags could come open. We specially treat the mailing bags in the direct area where the lip folds over to as this helps with the bond formed by the glue migrating into the film.
Storage; We recommend that mailing bags with Permanent Tape are stored at a temperature of 15 - 20 degrees and 50% relative Humidity. If the ambient temperature falls to less than zero - 5 degrees then you should ensure that you have a means of warming the mailing bags in use. This because the very cold temperature hardens the glue and so it takes longer to form a bond with the film.
Size in mm outer mailer: 250 x 350 + Lip +/- tolerance
Size in inches: 10 x 14 + Lip +/- tolerance
Approx usuable internal area: 235 - 245mm width x 340 - 350mm depth
Opening: on the 250mm side
Glue: Permanent Hot Melt x 1 Strip on the lip
Thickness of the Outer Poly Mailers: 50mu/50microns/200 gauge
Qty Per Box/Pack: 100
Outer box size: 500 x 400 x 300mm
Environmental Impact: These bags are 100% Recyclable and water resistant